1. One horn of a horn is located behind a forward decorative lattice in space between a radiator with the right head block headlight. The additional horn, is symmetrized concerning the first to the left of a radiator.
2. Disconnect an electrical wiring from a horn and give battery tension on one of its plugs. Ground the second plug (use wires crossing points). If the horn does not publish a sound signal, replace it.
3. At correct operation of a horn check serviceability of giving of tension for plugs of the contact socket of a horn when squeezing the klaksonny button. If food moves regularly, estimate quality of grounding of assembly.
4. If giving of food is broken, check a condition of the corresponding relay (see the Section of the Relay - the general information and check of serviceability of functioning). Pay attention that as klaksonny 4-contact assemblies, or 3-terminal relays grounded on the case are usually used.
5. If the relay as it should be, check serviceability of giving of tension in contours of its food and management. If at least one of contours is not powered, estimate a condition of the corresponding electrical wiring between the relay and the assembly block.
6. If food regularly moves on both contours of the relay, press the klaksonny button and check serviceability of grounding of the site of a chain between the button and the relay. In the absence of conductivity on weight, check a chain for break. If the break is absent, replace the horn switch.
7. If grounding of the klaksonny switch is not broken, check for break or short circuit an electrical wiring on the site of a chain between the relay and the switch. |
|
