Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 release

Repair and operation of the car



Toyota Land Cruiser, Amazon, Lexus LX470
+ Identification numbers of the car
+ Governing bodies and methods of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating of salon and air conditioning
+ A power supply system and production of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear shifting box
+ Transmission line
- Brake system
   Specifications
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes
   Removal and installation of supports of disk brake mechanisms
   Check of a state, removal and installation of a brake disk
   Removal and installation of the main brake cylinder (MBC)
   Check of a state and replacement of brake lines and hoses
   Sensitive to loading / перепускной valve (LSP & BP)
   Adjustment of the parking brake
   Replacement of cables of the drive of the parking brake
   Check of serviceability of functioning / tightness, removal and installation of the amplifier of brakes
   Pumping of the brake system
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning and replacement of the sensor switch of stoplights
   Sensors and activator of the ABS system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


08d33331



Replacement of cables of the drive of the parking brake

Components of assembly of the parking brake

1 — the Pin
2 — the Cranked lever of the drive of the parking brake
3 — the Clip
4 — the Forelock
5 — Pruzhina
6 — the Cover of the cranked lever
7 — the Arm of the cranked lever
8 — the Cable of the parking brake
9 — the Internal cable of the parking brake
10 — the Intermediate lever
11 — the Adjusting washer
12 — the Lock ring

13 — the Back disk brake mechanism
14 — the Returnable spring
15 — the Forward block
16 — the Expansion plate
17 — the Back block
18 — the Clamping spring
19 — the Brake disk
20 — Laying
21 — the Regulator
22 — spring Saddles
23 — the Holder of a block


Components of assembly of the parking brake are shown on an illustration above.

 PERFORMANCE ORDER

1. Release the parking brake. Weaken nuts of fastening of back wheels. The car also establish to Poddomkratta it on props. Remove wheels.
2. For a vybiraniye of a weak point of a driving cable weaken an adjusting nut (see the Section Adjustment of the Parking Brake).
3. Disconnect a cable from the cranked lever of the drive of the parking brake.
4. Disconnect an internal cable from the intermediate lever.
5. Release all cables from intermediate clamps on a bridge frame/case.
6. Installation is made upside-down.
7. Having finished installation, make adjustment of the drive of the parking brake.
8. Remove props and lower the car on the earth.