Removal and installation of a jet bar
Components of fastening of a jet bar
|
|
1. Prop up forward wheels antiretractable boots. A car back also establish to Poddomkratta it on props.
2. Prop up assembly of the back bridge a cart jack.
3. Disconnect from assembly of the back bridge the LSP & BP valve (see the Head the Brake system).
4. Disconnect the top end of a jet bar from the basic arm on the bearing car frame (address an illustration above).
5. Disconnect the lower end of a bar from a basic arm on assembly of the back bridge.
6. Remove a jet bar.
7. Installation is made upside-down. Track that all fixture was tightened with the required effort. Tightening of fixture is carried out after lowering of the car on the earth. |
|
|
